To make this quadcopter work, one must do the following:
- Make a wire harness using a servo lead and a USB type A. USB's positive should go to the servo leads red and white, negative to black. To charge the "radio adapter" of the q-bot, plug the servo lead so that the black wire is on top when facing the adapter. Plug the other part to a computer.
- If using a Turnigy 9X/9XR Tx, create a plane model, reverse ELE, THR and RUD. Turn it off. Remove RF module (if you haven't done the resistor mod) and plug the "radio adapter" in. Turn it on, Signal light should be ON.